Name of Project: The Eggcinerator
CAD Program Used: Autodesk 2008

Description:

Hard boiling eggs can be quite a hassle. Since I’m a wrestler I eat
very healthily. I love boiling eggs for my salads. I came up with
this idea because it seemed like every other time one of my eggs
would crack and result in pieces of hardboiled egg everywhere in
the pot which is a pain to clean up. It only takes a small crack
for eggs to break open while boiling. The eggs roll around in the
boiling water and will occasionally hit another egg or the side of
the pot hard enough to crack it. My design alleviates this problem.
The cook can place the eggs in the holders which keeps them from
bumping around in the boiling water and cracking. As well, this design
serves as a convenient holder to lift all of the eggs out at once
without having to scoop each individual egg out. There are large holes
that allow the cook to pop the eggs out using their hands and no extra
utensils are needed. If the need arose the cook could cook more than
four eggs by boiling four, lifting them out, leaving the water to boil,
replace and repeated.